| Visual Experiment Study on the influence of Mold Structure Design on Injection Molding Product’s Defects |
| 關鍵詞： |
Visualization Mold structure defects jetting w |
| 類 別： |
橡膠 >> 橡膠原料 |
| 來 源： |
2009高分子先進制造業論壇（青島） |
| 資料類型： |
pdf文件 |
| 資料大小： |
1109K |
| 簡 介： |
Injection molding visualization is the experimental method of direct
observation on the melt filling behavior in the mold cavity. By using developed
visualization system, the influence of mold structure design on the injection molding
product’s defects, such as jetting and weld were studied in this paper. The forming
process of jetting was observed by the visual method, and results show that it is useful
to avoid jetting by locating gate correctly. According to the generation of weld line in
single gate cavity, an improved measure to adjust the weld locations by adding
overflow traps was proposed. The result indicates that the overflow trap is good for
adjusting weld location and makes the defects appear in the unimportant points of
surface. Another experiment on the forming process of weld line in two-gate cavity
with setting different distance parameters were carried out. The result shows that
increasing of gates distance may significantly affect the performance of weld line. |
| 上傳人： |
chem2000 |
| 上傳時間： |
2009-11-05 13:43:00 |
| 下載次數： |
1 |
| 消耗積分： |
2 |
| 我要收藏： |
 |
| |
友情提示：下載后對該資源進行評論，即可獎勵2分。 |
|
本欄目部分資源來自互聯網，僅為促進數據共享和信息交流，如有版權問題請告知本網或上傳者本人，本網會及時給予答復。 |
| 報告錯誤
1.下載無效
2. 資料明顯無價值
3. 資料重復存在
|
